Little Tree Bali - Green Building Centre

• Used to fill joints up to 2 mm in width and other minor defects in wooden floors
• Can be used with all Bona finishes and oils and gives the flooring contractor the possibility to offer a complete waterborne system
• Works with all Bona finishing and oil systems 
• Free of solvents
• No unpleasant smell
• Fills the joints, but doesn’t slump
• Waterborne, but anti-corrosive
• Dries quickly
• Easy to sand

Bona - experts in wooden floor care since 1919

Bona AB is a family-owned company founded in 1919. With its headquarters in Sweden, Bona is now present in more than 70 different countries all over the world through subsidiaries and distributors.

They provide products for the installation, maintenance and renovation of wooden floors throughout their lifetime. Today they have solutions for professionals, homeowners and parquet producers.

Great concern for the environment 

Bona has great concern for the ones working with their solutions, living and enjoying them, and the environment affected by their actions and products, today and tomorrow.

They strive to continuously launch better products with less environmental impact. This has led to breakthrough innovations from waterborne finishes in the 1970s to dust-free sanding in the 2000s. Today, they are proud to be able to offer a full range of environmentally sound products for sanding, finishing, fastening and maintaining a wooden floor – throughout its lifetime.

Preparation 

• The surface to be filled must be clean, dry and free from contamination
• New floors and old floors should be sanded back to bare wood
• A sandpaper grade no. 100-120 should be used for the final sanding of the wood
• Do not discard the dust after you have finished sanding

Application

1. Shake well prior to use
2. Mix & Fill should be mixed with the dust from the earlier sanding process to make a texture suitable for application (use a steel spatula)
3. This mixture should then be applied across the whole surface of the floor. Larger joints may require additional applications.
   N.B. Mix&Fill is not suitable for floors with joints larger than 2 mm. Drying time: approx. 20 minutes at 20°C/55% R.H. This time may be extended where deep or wide joints are filled
4. After the Mix&Fill has dried, the surface of the floor should be sanded back to bare wood using an abrasive grade no. 100-120 and, if required, finished using the Bona Scrad system
5. The floor may then be treated using any of Bona finishes or oils

Maintenance 

• Bona Mix & Fill should always receive either an oil of lacquer treatment in order to protect from moisture, discoloration etc.

• Binding agent : Acrylate dispersion 
• Solvent : Water 
• Drying time : Approx. 20 minutes at 20°C/55% R.H. – 1 mm joints. This time may be extended where deep or wide joints are filled. 
• Application rate : Approx. 1 litre/10 m². This depends upon the quantity/depth of the joints. Maximum width of the joints : 2 mm 
• Safety : Unclassified 
• Flash point : Non-flammable 
• Shelf life : At least 1 year, from the date of production, in unopened original container 
• Storage / transport : The temperature must not fall below +5°C or exceed +25°C during storage and transport